Mazda Tribute 2002

Use of an incorrectly sized wheel bearing can adversely affect the braking and steering of the vehicle, increasing the risk of a crash.

Timken has begun notifying distributors who will offer purchasers replacement wheel bearings, free of charge. The recall began on May 21, 2015. Owners may contact Timken customer service at 1-866-984-6536.

A separation of the lower control arm can result in a significant loss of steering control, increasing the risk of a crash.

Mazda will notify owners, and dealers will install a newly designed reinforcement cross-brace, free of charge. The recall began on May 29, 2014. Owners may contact Mazda at 1-800-222-5500. Mazda's number for this recall is 7514D.

A stuck throttle may result in very high vehicle speeds and make it difficult to stop or slow the vehicle, which could cause a crash, serious injury or death.

Mazda will notify owners, and dealers will repair the vehicles by increasing the engine cover clearance, free of charge. Remedy parts are now available. The safety recall began on September 13, 2012. Owners may contact Mazda Customer Assistance Center at 1-800-222-5500, option #6.

CORROSION MAY DEVELOP IN THE ELECTRICAL CONNECTOR LEADING MELTING, SMOKING OR POSSIBLE FIRE.

MAZDA WILL NOTIFY OWNERS, AND DEALERS WILL REPLACE THE VEHICLE'S BRAKE MASTER CYLINDER RESERVOIR CAP AND MODIFY THE ABS ELECTRICAL SYSTEM, FREE OF CHARGE. UNTIL THE REPAIR HAS BEEN PERFORMED, VEHICLE OWNERS SHOULD PARK THEIR VEHICLES OUTSIDE. THE SAFETY RECALL BEGAN ON JUNE 22, 2012. OWNERS MAY CONTACT MAZDA AT 1-800-222-5500, OPTION 6.

AN ELECTRICAL SHORT MIGHT CAUSE AN ABS MALFUNCTION THAT WOULD ILLUMINATE THE ABS WARNING LIGHT, AND IN SOME CASES, THE MODULE MAY OVERHEAT RESULTING IN BURNING ODOR, SMOKE, AND/OR FIRE. THIS CONDITION COULD OCCUR EITHER WHEN THE VEHICLE IGNITION SWITCH IS IN THE OFF POSITION OR WHILE THE VEHICLE IS BEING OPERATED.

DEALERS WILL INSPECT THE WIRE HARNESS CONNECTOR TO THE ABS MODULE FOR MISSING OR DISLODGED WIRE SEALS, AND REPAIR OR REPLACE THE HARNESS CONNECTOR AS APPROPRIATE. THE DEALER WILL ALSO INSPECT THE CONNECTOR ON THE ABS MODULE AND REPLACE IT IF IT IS FOUND TO BE CORRODED OR DAMAGED. THE RECALL BEGAN ON MAY 9, 2007. OWNERS MAY CONTACT MAZDA AT 1-800-222-5500.

LOSS OF BRAKE FLUID CAN RESULT IN POOR BRAKING PERFORMANCE, POSSIBLY RESULTING IN A VEHICLE CRASH.

CARDONE WILL NOTIFY OWNERS AND OFFER TO REPURCHASE ANY DEFECTIVE MASTER CYLINDERS. THE RECALL BEGAN DURING APRIL 2007. OWNERS CAN CONTACT CARDONE AT 1-800-777-4780.

IF THE LIFTGATE IS LEFT UNLOCKED, THERE IS THE POTENTIAL THAT IT MAY OPEN DURING A CRASH.

DEALERS WILL REPLACE THE REAR LIFTGATE LATCH RELEASE ROD, THE RELEASE ROD ATTACHMENT CLIP AND THE DOOR HANDLE RETURN SPRING. THE RECALL BEGAN ON MARCH 31, 2005. OWNERS SHOULD CONTACT MAZDA AT 1-800-222-5500.

AN UNEXPECTED INCREASE IN ENGINE IDLE SPEED MAY INCREASE STOPPING DISTANCE AND MAY RESULT IN A VEHICLE CRASH.

DEALERS WILL REPLACE THE ACCELERATOR CABLE. THE RECALL BEGAN ON JANUARY 28, 2005. OWNERS SHOULD CONTACT MAZDA AT 1-800-222-5500, OPTION #4.

SHOULD THE ENGINE STALL, A VEHICLE CRASH COULD OCCUR.

DEALERS WILL REPROGRAM THE POWER CONTROL MODULE (PCM) WITH THE APPROPRIATE CALIBRATION. THE RECALL BEGAN ON MAY 3, 2004. OWNERS SHOULD CONTACT MAZDA AT 1-800-222-5500.

On certain vehicles registered and operated in areas where road salt is used on the roadways during winter months for extended time periods (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland-Labrador), the forward attachment point for the lower control arm may separate from the vehicle's subframe. This could affect vehicle handling and increase the risk of a crash causing injury and/or property damage. Correction: Dealers will install a newly designed reinforcement cross-brace. Note: this is an expansion of recall 2014-117.

On certain vehicles registered and operated in areas where road salt is used on the roadways during winter months for extended time periods (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland-Labrador), the forward attachment point for the lower control arm may separate from the vehicle's subframe. This could affect vehicle handling and increase the risk of a crash causing injury and/or property damage. Correction: Dealers will install a newly designed reinforcement cross-brace.

On certain vehicles equipped with a 3.0L V6 engine and speed control, inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. A stuck throttle may result in very high vehicle speeds and make it difficult to slow or stop the vehicle if the transmission is not shifted into neutral. This could result in a crash causing property damage and/or personal injury. Correction: Dealers will replace the rear engine cover fastener, which will raise the cover in the area of the speed control cable to provide adequate clearance between the cover the speed control cable connector.

Certain vehicles may have been originally equipped with a brake master cylinder reservoir cap that could leak. If brake fluid leaks from the cap, it could come in contact with the ABS module wiring harness connector. The same vehicles were previously involved in campaign 2007119 to address potentially missing or misplaced seals in the wiring harness connector to the ABS module electronic control unit. If this repair wasn’t done correctly, brake fluid leaking from the reservoir cap could corrode the ABS module electrical connector. This could result in vehicle fire causing property damage and/or personal injury. Correction: Dealers will replace the brake master cylinder reservoir cap and modify the ABS electrical system. Note: Owners are advised to park the vehicle outdoors until the remedy is applied.

On certain vehicles, the electrical wiring connector to the ABS module may have been manufactured incorrectly. Over time, contaminants can enter the ABS electrical connector interface and corrode the terminals. This could cause the ABS warning indicator to illuminate, an open fuse, and in some instances, smoking, melting or burning of the electrical connector, with the potential for a fire while the vehicle is unattended. In addition, ABS function may be lost. Correction: Dealers will inspect and, if required, repair the wiring connector.

On certain vehicles equipped with 3.0L V6 engines, the accelerator cable's inner liner may, over time, migrate out of the conduit at the dash panel fitting during vehicle operation. The liner may migrate to the point that it contacts the accelerator pedal arm. Under these conditions the liner may prevent the pedal from fully returning, which may not allow the throttle body to fully return to the "idle" position. Typically the condition results in a progressive increase in the "idle" speed if liner migration continues over time, but may cause a more sudden increase if a greater portion of the cable moves at one time. An unexpected increase in "idle" speed may result in longer than expected stopping distances, which could potentially lead to a crash. Correction: Dealers will replace the accelerator cable.

On certain vehicles equipped with a 3.0L V6 engine, during deceleration at vehicle speeds below 64 km/h, the engine may stall due to an excessively rich fuel-air mixture. Correction: Dealer will reprogram the Powertrain Control Module.