Jeep Wrangler 2005

The contact owns a 2005 Jeep Wrangler. The contact stated that while driving 55 MPH, the vehicle stalled. The check engine warning light was flashing. The contact pulled over to the side of the road. The vehicle failed to restart and was towed to the residence. The vehicle was then towed to three different independent…

Engine warning light has been coming on since about 70k miles(190k now). Scanner says O2 sensor is bad. After replacement of the O2 sensor, the fault continues to show up randomly. I carry a scanner to reset the engine code on the road. All wiring has been checked and is ok. When I clear the code, the error does …

As I was driving home from work on Feb. 14, 2023, in Rocky Hill, NJ. the vehicle developed a sudden loss of steering control. I had it towed to Chrysler Dodge Jeep RAM of Princeton, NJ. The service manager informed me that the area of the frame to which the steering gear box is bolted had completely rotted, and the s…

Ecm computer , o2 heater sensor from ecm and controls transmission shift points . Replaced o2 sensors and transmission is controlled by ecm not shifting correctly will stay in first gear and hard shift to second can create loss of control in wet weather conditions.

Keep wobble almost caused head on collision afraid to drive vehicle over 55 mph

The dashboard will display odd behavior and all of a sudden the ignition will cut. Total loss of power. This has happened in the past with children in the vehicle. Very dangerous. Resetting the key will reset but it is random.

The contact owns a 2005 Jeep Wrangler. The contact stated while driving approximately 65 mph, the vehicle loss motive power. Several gauges became inoperable with unknown warning lights illuminated. The contact pulled over and waited approximately 15 minutes before the vehicle was restarted. The vehicle was towed to t…

Engine failed, speedometer, tach went to 0, all gauges went to 0, power steering failed after I declutched and then coasted to a full stop (power brakes failed but still had some brake input) safely on the shoulder of an off ramp. (This not the first time this has happened, however it was the first time pulling a full…

At every fuel fill up, gasoline splashes back out onto the vehicle, the person filling the vehicle and creates a very unsafe puddle of gasoline on the ground. There is never a time that it does not happen. I would be readily available to make my vehicle available for inspection of this concern. Chrysler has issued r…

The camshaft sensor upper bushing does not get lubricated seizes up causes camshaft to wear out. In my jeep I replaced three of them on the inline 4.0 6cyl. I only have 66,660 miles on my jeep. June 4, 2021.

ECU STOPED WORKING NO REASON.

THE PCM HAS A KNOWN HIGH FAILURE RATE DUE TO THE VIBRATION. THE COMPONENTS ARE COVERED IN A RESIN THAT YOU CAN NOT REMOVE. THE PCM IS 500-1300 TO GET A REPAIRED AND REPROGRAMED ONE. I HAVE A 2005 AND THE PCM HAS FAILED AND GIVES BAD PERFORMANCE AND DOES NOT RUN ON TEH 14.7 STOKES FOR AIR/FUEL/ IT DUMPS FUELS AND I DO …