GMC Yukon 2000

WHEEL SEPARATION CAN RESULT IN A VEHICLE CRASH.

FEDERAL-MOGUL WILL NOTIFY CUSTOMERS AND WILL REPLACE THE HUB ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 7, 2008. OWNERS CAN CONTACT FEDERAL-MOGUL TOLL-FREE AT 877-489-6659.

THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.

HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).

THIS CAN CAUSE INCREASED STOPPING DISTANCES DURING LOW-SPEED BRAKE APPLICATIONS, WHICH COULD RESULT IN A CRASH.

DEALERS ARE TO REMOVE THE WHEEL SPEED SENSOR AND THOROUGHLY CLEAN THE WHEEL SPEED SENSOR MOUNTING SURFACE ON THE BEARING, APPLY RUST INHIBITOR TO THE CLEANED SURFACE, GREASE THE MOUNTING SURFACE, REINSTALL THE WHEEL SPEED SENSOR, AND CHECK THE PEAK-TO-PEAK OUTPUT VOLTAGE TO ENSURE THE WHEEL SPEED SIGNAL IS WITHIN SPECIFICATIONS. THE RECALL BEGAN SEPTEMBER 22, 2005. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438 OR GMC AT 1-866-996-9463.

THIS OVERHEATING CONDITION CAN CAUSE THE RUNNING BOARD TO MELT OR CAUSE A FIRE.

DEALERS WILL REPLACE THE WIRING HARNESS ON THESE RUNNING BOARDS. OWNER NOTIFICATION BEGAN MARCH 7, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT SOUTHERN COMFORT AT 1-800-745-6096.

IF A PERSON WERE TO INSERT THEIR FINGER(S) INTO THE PINCH POINT WHEN THE HEAD RESTRAINT FOLDS, IT COULD TRAP AND PINCH THE FINGER(S) CAUSING INJURY.

DEALERS WILL INSTALL PROTECTIVE COVERS OVER THE PINCH POINTS. OWNER NOTIFICATION BEGAN NOVEMBER 8, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020, GMC AT 1-800-462-8782, OR CADILLAC AT 1-800-458-8006.

IN A VEHICLE CRASH, FRONT SEAT OCCUPANTS MAY RECEIVE MORE SEVERE INJURIES.

DEALERS WILL RECALIBRATE THE SDM ON THE AFFECTED VEHICLES. OWNER NOTIFICATION BEGAN AUGUST 28, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020 OR GMC AT 1-800-462-8782.

TREAD BELT SEPARATION MAY BE NOTICED BY IRREGULAR WEAR, NOISE, OR VIBRATION. WITH CONTINUED USE, IT MAY LEAD TO COMPLETE SEPARATION OF THE TREAD/BELT PACKAGE FROM THE TIRE CARCASS, POSSIBLY RESULTING IN A VEHICLE CRASH, PERSONAL INJURY, OR DEATH.

ON JANUARY 2, 2001, FIRESTONE MADE A PUBLIC ANNOUNCEMENT OF THE DEFECT AND THAT REPLACEMENT TIRES ARE IMMEDIATELY AVAILABLE AT NO COST TO THE CUSTOMER. REPLACEMENT TIRES ARE AVAILABLE AT EITHER THEIR LOCAL GM OR CHEVROLET DEALER OR BY THEIR LOCAL AUTHORIZED PARTICIPATING FIRESTONE RETAILER. OWNER NOTIFICATION BEGAN JANUARY 1, 2001. OWNERS SHOULD CONTACT FIRESTONE AT 1-800-465-1904.

DURING BRAKING, THE PEDAL WILL BE LOWER THAN NORMAL AND STOPPING DISTANCES WILL BE LONGER. IF THIS OCCURS WHEN STOPPING DISTANCE IS LIMITED, A CRASH COULD OCCUR.

DEALERS WILL INSPECT THE FRONT RIGHT-HAND BRAKE PIPE FOR WEAR. IF THERE ARE SIGNS OF WEAR, THIS SECTION OF THE BRAKE PIPE WILL BE REPLACED WITH A NEW DESIGNED BRAKE PIPE SECTION. IF THERE ARE NOT SIGNS OF WEAR ON THE BRAKE PIPE, THE DEALER WILL INSTALL A SPACER CLIP TO ENSURE SUFFICIENT CLEARANCE BETWEEN THE BRAKE PIPE AND THE BODY CROSS SILL.

THESE GASES COULD FLOW INTO THE PASSENGER COMPARTMENT IF THE PLUG IS MISSING OR LOOSE AND COULD CAUSE POSSIBLE ILLNESS, UNCONSCIOUSNESS, OR DEATH.

DEALERS WILL INSPECT THE VEHICLE FOR LOOSE OR MISSING WHEELHOUSE PLUGS AND INSTALL NEW PLUGS IF NECESSARY.

Certain vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador may experience unwanted Antilock Brake System (ABS) activation and increased stopping distances during low-speed brake application (less than 16 km/h and greater than 6 km/h). This condition does not set any ABS codes nor does it illuminate the ABS warning lamp. Correction: Dealers will remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply Zinc-X to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the output voltage to ensure the wheel speed signal is within specifications.

Certain vehicles equipped with rearward folding head restraints on the second row seats. Two potential pinch points exist on each of the folding head restraints when the head restraint(s) are folded rearward as the seatback is folded down. If a person were to insert their finger(s) into the pinch point when the head restraint folds, it could trap and pinch the finger(s) causing injury. Correction: Dealers will install protective covers over the pinch points.

Certain vehicles have an air bag sensing diagnostic module (SDM) which contains an anomaly that could result in the driver and passenger's air bag failing to deploy during certain frontal collisions. In a vehicle crash, front seat occupants may receive more severe injuries. Correction: Dealers will recalibrate the SDM.

Certain vehicles may have loose or missing rear wheelhouse plugs. Under certain operating conditions, exhaust gases can flow forward and accumulate in the rear wheelhouse. These exhaust gases could flow into the passenger compartment if the wheelhouse plug is missing or loose and may cause possible illness, unconsciousness or death. Correction: Dealers will inspect for loose or missing wheelhouse plugs, and install new plugs if necessary.

On certain vehicles, the body cross sill may contact the front, right-hand brake pipe. This could eventually wear a hole in the brake pipe over the normal life of the vehicle and result in a brake fluid leak. This could ultimately result in a partial brake system failure and increased stopping distances. Correction: Dealers will inspect for brake pipe wear and replace worn section if necessary. A spacer clip will be installed to ensure adequate clearance.

Certain vehicles do not comply with the requirements of C.M.V.S.S. 105 - Hydraulic and Electric Brake Systems. Vehicles may have a kinked brake booster vacuum supply hose which could increase stopping distances in multiple brake applications. Correction: Brake vacuum booster supply hose will be rerouted.