Ford Focus Station 2000

IF THE ASSEMBLY SEPARATES DURING INSTALLATION, IT COULD RESULT IN INJURY TO THE INSTALLER. IF THE ASSEMBLY SEPARATES WHILE THE VEHICLE IS IN MOTION, IT COULD RESULT IN SECONDARY DAMAGE TO THE VEHICLE AND POSSIBLY RESULT IN A VEHICLE CRASH.

RIDE CONTROL WILL NOTIFY OWNERS AND WILL SET UP PROCEDURES TO INSPECT, REPAIR, AND/OR REPLACE THE AFFECTED PARTS WITHOUT CHARGE TO THE OWNER. THE SAFETY RECALL BEGAN ON MARCH 30, 2012. OWNERS MAY CONTACT RIDE CONTROL AT 1-800-999-3903.

DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.

DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

WITHOUT THE AMBER SIDE REFLEX REFLECTORS, THE LIGHTING VISIBILITY MAY BE AFFECTED, POSSIBLY RESULTING IN A VEHICLE CRASH.

K2 MOTOR WILL NOTIFY OWNERS AND OFFER A FULL REFUND. THE RECALL BEGAN ON DECEMEBER 17, 2008. OWNERS MAY CONTACT K2 MOTOR AT 1-909-839-2992.

WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

CK MOTORSPORT WILL NOTIFY OWNERS AND REPLACE THE NONCOMPLIANT LAMPS FREE OF CHARGE. THE RECALL BEGAN ON JULY 1, 2006. OWNERS MAY CONTACT CK MOTORSPORT AT 1-909-610-7211.

WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

IF NOT LATCHED PROPERLY, THE DOOR MAY OPEN WHILE THE VEHICLE IS IN MOTION. IF AN OCCUPANT FELL OUT OF THE VEHICLE, PERSONAL INJURIES COULD OCCUR.

DEALERS WILL HAVE A LOWER ROCKER SEAL ADDED TO THE DOOR AND HAVE THE REAR DOOR LATCHES EVALUATED FREE OF CHARGE. A LATCH THAT PASSES THE EVALUATION WILL BE LUBRICATED TO PREVENT FUTURE CORROSION. A LATCH THAT DOES NOT PASS THE EVALUATION WILL BE REPLACED. IN ADDITION, A STICKER WILL BE AFFIXED TO THE REAR DOORS ADVISING THE OWNERS TO USE THE RECOMMENDED LUBRICANT. THE RECALL BEGAN ON MARCH 9, 2005. OWNERS MAY CONTACT FORD AT 1-800-392-3673.

THIS MAY CAUSE ENGINE HESITATION, LOSS OF POWER, SURGING, AND OTHER SIMILAR SYMPTOMS. OVER TIME, THE FILTER MAY BECOME SUFFICIENTLY BLOCKED TO CAUSE THE ENGINE TO STALL, WHICH COULD RESULT IN A CRASH.

THIS ACTION IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN AND IS NOT BEING CONDUCTED UNDER THE SAFETY ACT. ALL OWNERS WILL BE NOTIFIED OF THE PROBLEM, AND DEALERS WILL REPLACE THE FDM WITH A NEW DESIGN AT NO CHARGE IF THE OWNER REPORTS THAT THE VEHICLE EXHIBITS ANY OF THE IDENTIFIED SYMPTOMS. THE FREE REPLACEMENT WILL BE AVAILABLE FOR A PERIOD OF 10 YEARS FOLLOWING THE ORIGINAL PURCHASE OF THE VEHICLE, WITH NO MILEAGE LIMIT. OWNER NOTIFICATION IS EXPECTED TO BEGIN DURING NOVEMBER 2003. OWNERS SHOULD CONTACT FORD AT 1-800-392-3673.

LOOSE PINCH BOLTS COULD EXHIBIT NOISE, VIBRATION AND, IN EXTREME CASES IF LEFT UNCORRECTED, SEPARATION OF THE JOINT OR FRACTURE OF THE BALL JOINT STUD, INCREASING THE RISK OF A CRASH.

DEALERS WILL INSPECT THE STEERING KNUCKLE PINCH BOLT FOR TIGHTNESS AND CORRECT AS NECESSARY. OWNER NOTIFICATION BEGAN FEBRUARY 10, 2003. OWNERS WHO DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-866-436-7332.

THIS, IN TURN, COULD CAUSE THE BATTERY CABLES TO SHORT RESULTING IN HEAT DAMAGE TO THE CABLES. BESIDES HEAT DAMAGE, THE "CHECK ENGINE" LIGHT MAY ILLUMINATE, THE VEHICLE MAY FAIL TO START, OR SMOKE, MELTING, OR FIRE COULD ALSO OCCUR.

DEALERS WILL INSPECT THE BATTERY CABLES FOR THE CONDITION OF THE CABLE INSULATION AND PROPER TIGHTENING OF THE TERMINAL ENDS. AS NECESSARY, CABLES WILL BE REROUTED, RETAINING CLIPS INSTALLED, AND DAMAGED BATTERY CABLES REPLACED. OWNER NOTIFICATION BEGAN FEBRUARY 10, 2003. OWNERS WHO DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-866-436-7332.

THE WHEEL BEARINGS COULD PREMATURELY WEAR AND CAUSE A NOTICEABLE NOISE. IF NOT REPAIRED, THIS CONDITION COULD PROGRESS TO THE POINT WHERE THE WHEEL BEGINS TO WOBBLE.

DEALERS WILL REPLACE THE REAR WHEEL BEARINGS AT NO COST TO THE CONSUMER. ADDITIONAL BEARING SEALS WILL ALSO BE INSTALLED TO ENSURE A SMOOTH RIDE. THIS PROGRAM WILL BE IN EFFECT UNTIL DECEMBER 31, 2002, REGARDLESS OF MILEAGE. EVEN IF THE VEHICLE HAS ALREADY BEEN SERVICED UNDER RECALL CAMPAIGN 00S31, FORD HAS TAKEN ADDITIONAL STEPS TO KEEP THE WHEEL BEARINGS IN TOP SHAPE. OWNERS CAN CONTACT FORD AT 1-866-436-7332, CONCERNING THIS PROGRAM.

LOSS OF VISIBILITY WHILE DRIVING INCREASES THE RISK OF A CRASH.

DEALERS WILL INSPECT THE DATE CODE ON THE WIPER MOTOR. MOTORS BUILT WITH THE SUSPECT TIME FRAME WILL HAVE THE WIPER MOTOR GEAR CASE COVER REPLACED. OWNER NOTIFICATION BEGAN AUGUST 20, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-866-436-7332.

IF THE SEAT IS THEN RETURNED TO THE UPRIGHT POSITION WITHOUT RE-ENGAGING THE HINGE PIVOT, THE SEAT AND SEAT BELTS MAY NOT PROVIDE THE INTENDED LEVEL OF PERFORMANCE IN THE EVENT OF A CRASH.

DEALERS WILL INSTALL A REVISED SEAT BACK HINGE PIVOT.

THIS COULD RESULT IN EITHER A LOSS OF INDIVIDUAL LAMP FUNCTIONS, OR IN THE CASE OF A SHORT OF THE BROKEN WIRES THAT CAUSES A FUSE TO OPEN, IN THE LOSS OF STOP LAMP OR TAIL LAMP FUNCTION. LOSS OF STOP LAMP OR TAIL LAMP FUNCTION COULD INCREASE THE RISK OF A CRASH.

DEALERS WILL REPLACE THE DECKLID WIRE HARNESS.

THIS CONDITION COULD RESULT IN A VEHICLE CRASH.

DEALERS WILL INSPECT THE REAR WHEEL BEARINGS AND INSTALL A REAR WHEEL RETENTION CAP TO PREVENT LEFT REAR WHEEL SEPARATION. OWNER NOTIFICATION BEGAN OCTOBER 12, 2000. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-800-392-3673.

A THROTTLE THAT DOES NOT RETURN TO IDLE COULD RESULT IN REDUCED VEHICLE CONTROL AND, POTENTIALLY, A VEHICLE CRASH.

DEALERS WILL INSPECT THESE VEHICLES AND, IF NECESSARY, REPLACE THE SPEED CONTROL CABLE. OWNER NOTIFICATION BEGAN OCTOBER 12, 2000. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-800-392-3673.

IN THE EVENT OF A CRASH, AN OCCUPANT CONTACTING THAT LOCATION MAY NOT BE PROVIDED THE INTERIOR IMPACT PROTECTION INTENDED.

DEALERS WILL REMOVE THE LEFT AND RIGHT SIDE B-PILLAR AND A-PILLAR TRIM PANELS, REVISE THE HEADLINER EDGE NEAR THE TOPS OF THE A-PILLARS TO ACCEPT THE NEW A-PILLAR TRIM PANELS WITH THEIR ENERGY ABSORBING TUBES, AND INSTALL THE NEW A-PILLAR AND THE OLD B-PILLAR TRIM PANELS.

A THROTTLE THAT DOES NOT RETURN TO IDLE COULD RESULT IN UNEXPECTED ACCELERATION, INCREASING THE RISK OF A CRASH.

DEALERS WILL REPLACE THE SPEED CONTROL CABLE (WITH A NEW CABLE THAT INCORPORATES A GLASS-FILLED END CAP) AND INSPECT THE ASSEMBLY FOR INTERNAL CORROSION. SERVOS WITH EVIDENCE OF CORROSION WILL ALSO BE REPLACED. OWNERS ARE ADVISED NOT TO USE THE SPEED CONTROL UNTIL THE VEHICLES ARE REPAIRED.

Certain four door (sedan and wagon) and five door vehicles originally sold or currently registered in the provinces of Newfoundland and Labrador, Prince Edward Island, Nova Scotia, New Brunswick, Quebec, and Ontario may have faulty rear door latches. Corrosion build-up at the pawl pivot area of the latch can cause the latch to bind. The owner may experience difficulty opening or closing a rear door, and eventually the rear door may not latch properly. If not latched properly the door may open while the vehicle is in motion. Correction: Dealers will inspect the rear door latches. A latch that passes the evaluation will be lubricated to prevent future corrosion. A latch that does not pass the evaluation will be replaced.

On certain vehicles, insufficient clamp load at the attachment of the lower control arm ball joint to the steering knuckle may result in separation of the joint or fracture of the ball joint stud. If this should occur while the vehicle is in motion, loss of vehicle control may result. Correction: Dealers will verify the torque of the steering knuckle pinch bolt and tighten as necessary.

On certain vehicles equipped with a Zetec engine, the battery cable insulation could be damaged due to loose or broken attachments and/or misrouted battery cables. This in turn may cause the battery cables to short resulting in heat damage. The check engine light being illuminated or the engine failing to start are some of the possible symptoms however, smoke, melting or fire may also occur. Correction: Dealers will inspect the condition or the battery cable insulation for proper torque at the terminal ends. Cables will be rerouted, retaining clips installed and damaged battery cables replaced as necessary.

Certain passenger cars, sport utility vehicles, and light and medium duty pickup trucks. A switch located in the plastic cover of the wiper motor gear case could malfunction and overheat, potentially resulting in loss of intermittent wiper function, loss of wiper park function, complete loss of wiper function, smoke or, potentially, ignition of the plastic cover material. Switch malfunction is most likely to occur when the intermittent setting of the wipers is being used, or when snow or ice obstructs the blades from returning to the "parked" position at the bottom of the windshield. Loss of visibility while driving increases the risk of a crash. Correction: Dealers will inspect the date code on the wiper motor. Motors built with the suspect time frame will have the wiper motor gear case cover replaced.

On certain vehicles, the decklid wiring harness may fatigue and develop broken wires in the bend area of the wire harness in the grommet on the decklid. This may occur due to a rigid vinyl sleeve that is located at the bend point. Broken wires could result in either a loss of individual lamp functions, or in the case of a short that causes a fuse to open, in the loss of stop lamp or tail lamp function. Correction: Decklid wire harness will be replaced with a wire harness that has a longer, more flexible sleeve.

Certain station wagons and 3 door vehicles come equipped with a folding 60/40 second seat that becomes a load floor in the folded position. When the 60% portion of the seat is folded, if a load is applied to the front edge of the load floor, the outboard hinge pivot could disengage from the hinge. If the seat is then returned to the upright position without re-engaging the hinge pivot, the seat, and seat belts may not provide the intended level of performance in the event of a crash. Correction: Dealers will install a revised seat back hinge.

Certain vehicles have a speed control cable that may have a core wire that is long enough to catch on the sleeve at the throttle body end of the cable during wide open throttle acceleration. If this occurs, the throttle may stick and not return to idle when the accelerator is released. A stuck throttle could result in result in reduced vehicle control and a possible crash. Correction: Vehicles will be inspected and speed control cable will be replaced if necessary.

Certain vehicles may have rear wheel hubs that could loosen and allow the left rear wheel and brake drum assembly to separate from the vehicle. Separation of a rear wheel and brake drum could result in reduced vehicle control and a possible crash. Correction: Vehicles will be inspected and, if necessary, rear wheel hub and bearing assembly will be replaced. In addition, a redundant left rear wheel retention device will be added to the left rear spindle.

Certain vehicles do not comply with the requirements of CMVSS 1101 - Emission Device. The Injector Pressure Sensor (IPS), located on the end of the fuel rail, may become contaminated with water during shipping to the assembly plant. This water could freeze in low ambient temperatures and cause the IPS membrane to crack or burst, resulting in possible illumination of the Malfunction Indicator Light (MIL), engine no start and internal engine damage due to hydro-locking. Correction: Dealers will replace the IPS.

On certain vehicles, the speed control cable end fitting may allow water to enter the speed control servo assembly. If this occurs, corrosion in the servo assembly could develop and cause intermittent speed control operation or prevent the throttle from returning to idle. This could result in unexpected acceleration and, potentially, a vehicle crash. Correction: Speed control cable will be replaced, speed control servo will be inspected for internal corrosion. Servos with evidence of corrosion will also be replaced.