Chevrolet Express 2004

Significant corrosion may allow fuel to leak during refueling, and in the presence of an ignition source; there is an increased risk of fire.

GM will notify owners, and dealers will install a new fuel filler neck, free of charge. The safety recall began on October 1, 2012. Owners may contact the Chevrolet owner center at 1-866-694-6546 and GMC at 1-866-996-9463.

DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

IN THE EVENT OF A CRASH, A SEAT OCCUPANT MAY NOT BE PROPERLY RESTRAINED INCREASING THE RISK OF PERSONAL INJURY.

DEALERS WILL INSPECT THE BUCKLES AND, IF FOUND TO BE INOPERATIVE, THE ENTIRE BUCKLE ASSEMBLY WOULD BE REPLACED. FOR BUCKLES FOUND TO BE OPERATIVE, DEALER WILL REPLACE ONLY THE UPPER BUCKLE COVER. THE RECALL WILL BE CONDUCTED IN PHASES. THE FIRST PHASE MAILING BEGAN DURING MARCH 2006. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438 OR GMC AT 1-866-996-9463.

IF A SEPARATION OCCURRED AND THE HOOD OF THE VEHICLE WERE OPEN, FRAGMENTS FROM THE ACCUMULATOR COULD CAUSE INJURY TO PEOPLE IN THE IMMEDIATE AREA. THE PRESENCE OF THIS CRACK OR FRACTURED SURFACE COULD ALLOW THE HYDRAULIC FLUID TO LEAK FROM THE ACCUMULATOR CIRCUIT OF THE BOOSTER ASSEMBLY. THE LOSS OF FLUID WOULD CAUSE INCREASED STEERING AND BRAKING EFFORT AND A CRASH MAY OCCUR WITHOUT PRIOR WARNING.

DEALERS WILL TEST THE HYDRO-BOOST ASSEMBLY FOR FUNCTIONAL OPERATION OF THE TWO-FUNCTION VALVE. IF THE HYDRO-BOOST ASSEMBLY FAILS THE TEST, DEALERS WILL REPLACE THE ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON MARCH 23, 2005. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, GMC TRUCKS AT 1-866-996-9463 AND HUMMER AT 1-800-732-5493.

IF THIS WERE TO OCCUR, THE VEHICLE COULD MOVE IN A DIRECTION NOT ANTICIPATED BY THE DRIVER, WHICH COULD RESULT IN A VEHICLE CRASH.

DEALERS WILL INSPECT THE TRANSMISSION SHIFT CABLE ASSEMBLY, AND IF NECESSARY, REPLACE IT. THE RECALL BEGAN ON AUGUST 19, 2004. OWNERS SHOULD CONTACT CHEVROLET AT 1-800-630-2438 OR GMC AT 1-866-996-9463.

THE SAFETY BELT MAY NOT RESTRAIN THE OCCUPANT AS INTENDED DURING A CRASH, WHICH COULD RESULT IN INJURY TO THE OCCUPANT.

DEALERS WILL REPLACE THE SAFETY BELT BUCKLE. THE RECALL BEAGN MAY 7, 2004. OWNERS SHOULD CONTACT CHEVROLET AT 1-800-630-2438 OR GMC AT 1-866-996-9463.

CONSEQUENTLY, THE VALVE O-RING SEAL MAY FRACTURE. STEERING EFFORTS MAY BE SLIGHTLY INCREASED WHILE BRAKING OR PARKING. UNDER CERTAIN DRIVING CONDITIONS, A FRACTURED SEAL MAY REQUIRE A SLIGHT INCREASE IN THE APPLIED BRAKE PEDAL EFFORT TO ACHIEVE THE SAME VEHICLE DECELERATION RATE AS PRIOR TO THE SEAT FRACTURE.

DEALERS ARE TO REPLACE THE HYDRO-BOOST RELIEF VALVE. THE RECALL BEGAN ON JUNE 18, 2004. OWNERS SHOULD CONTACT CADILLAC AT 1-866-982-2339; CHEVROLET AT 1-800-630-2438; GMC AT 1-866-996-9463; OR HUMMER AT 1-866-486-6376.

Issue: On certain vehicles, an unused wiring harness for a rear HVAC blower motor, located in the left B-pillar area, could become damaged if exposed to moisture or contaminants. If this happens, the wires could short circuit. Note: This recall only affects cutaway chassis incomplete vehicles. Safety Risk: A short circuit can create the risk of a fire. Corrective Actions: General Motors will notify owners by mail and instruct you to bring your vehicle to a dealership to seal the wiring for the rear HVAC blower motor at the left B-pillar.

On certain vehicles equipped with a left side cargo door, and originally sold in or currently operated in areas of heavy road salt usage during winter months (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador), the fuel filler pipe could corrode and become perforated. This could allow fuel to leak onto the ground while refuelling the vehicle. Fuel leakage, in the presence of an ignition source, could result in a fire causing property damage and/or personal injury. Correction: Dealers will replace the fuel filler pipe.

Certain full-size passenger, cargo and cutaway vans may have front and rear seat belt buckles that will not latch or will not unlatch. There are two conditions that render the buckle inoperative after customer usage. Specifically, (1) with a damaged ejector hood, the latch tongue cannot fully enter the buckle and will not latch, and (2) if the release bar moves permanently out of position the buckle will either be unable to engage the latch or the pushbutton will be unable to unlatch the buckle. Correction: Dealers will inspect buckles and, if found to be inoperative, the entire buckle assembly will be replaced. Note: This is an expansion of recall 2005390.

Certain full-size passenger, cargo and cutaway vans may have front and rear seat belt buckles that will not latch or will not unlatch. There are two conditions that render the buckle inoperative after customer usage. Specifically, (1) with a damaged ejector hood, the latch tongue cannot fully enter the buckle and will not latch, and (2) if the release bar moves permanently out of position the buckle will either be unable to engage the latch or the pushbutton will be unable to unlatch the buckle. Correction: Dealers will inspect buckles and, if found to be inoperative, the entire buckle assembly will be replaced.

On certain vehicles, the hydraulic brake booster's pressure accumulator may crack and/or separate from the Hydro-Boost assembly during normal vehicle operating conditions. If a separation occurred and the hood of the vehicle was open, fragments from the accumulator could cause injury to people in the immediate area. In addition, the presence of this crack or fractured surface could allow the hydraulic fluid to leak from the accumulator circuit of the booster assembly. The loss of fluid would cause increased steering and braking effort. Correction: Dealers will test and, if necessary, replace the Hydro-Boost assembly.

On certain vehicles, the transmission shift cable may allow the transmission indicator (PRNDL) to indicate a different gear selected than the transmission is in. If this condition occurred while a vehicle is resting on an uneven surface, the vehicle could roll away after the driver has exited. Correction: Dealer will inspect and replace the transmission shift cable assembly.

Certain vehicles do not comply with the requirements of CMVSS 209, "Seat Belt Assemblies". These vehicles may have been produced with seat belt buckle assemblies containing a latch with a brittle condition that may not withstand the force requirements of the standard. In a crash, if the safety belt buckle fails, an occupant's injuries could be greater. Correction: Dealer will install new seat belt assemblies.

On certain vehicles, the relief valve o-ring seal within the brake hydro-boost module could fail. If this happens during braking applications, the driver may be able to hear an engine compartment noise similar to the sound that occurs when the steering wheel is turned to a full stop position. The driver could also experience a slight increase in steering efforts while braking and parking. Under certain driving conditions, a slight increase in the applied brake pedal effort may be required to achieve the same vehicle deceleration rate as prior to the seal failure. Correction: Dealers will inspect the hydro-boost module, and replace it, if necessary.