Ford Freestar Cargo 2004

In the event that the vehicle is crashed into from the rear, an unlatched seat may increase the risk of personal injury.

Ford will notify owners, and dealers will install new third row seat latch striker mounting brackets, free of charge. The recall began on March 28, 2013. Owners may contact Ford Motor Company Customer Relationship Center at 1-866-436-7332.

THIS CONDITION RESULTS IN A SUDDEN LOSS OF MOTIVE POWER WITH NO WARNING, INCREASING THE RISK OF A CRASH.

FORD WILL NOTIFY OWNERS, AND DEALERS WILL REPLACE THE TORQUE CONVERTER FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 9, 2012. OWNERS MAY CONTACT THE FORD MOTOR COMPANY CUSTOMER RELATIONSHIP CENTER AT 1-866-436-7332.

FAILURE OF THIS CONNECTION COULD LEAD TO FUEL SPILLAGE AND, IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.

UFI WILL NOTIFY OWNERS AND REPLACE THE FILTERS FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 4, 2006. OWNERS MAY CONTACT UFI FILTERS USA AT 800-230-5876.

IF THE CRACKS WERE TO PROGRESS, THIS COULD EVENTUALLY RESULT IN WHEEL SEPARATION. WHEEL SEPARATION MAY LEAD TO LOSS OF VEHICLE CONTROL, AND POTENTIALLY RESULT IN A VEHICLE CRASH.

DEALERS WILL REPLACE THE FRONT HUB, ROTORS, AND WHEEL BEARINGS. THE RECALL BEGAN SEPTEMBER 20, 2004. OWNERS SHOULD CONTACT FORD AT 1-800-392-3673.

IF THIS LINE BECOMES DISCONNECTED, IT MAY CREATE THE POTENTIAL FOR FLUID TO COME INTO CONTACT WITH THE EXHAUST SYSTEM, WHICH COULD RESULT IN SMOKE OR FIRE.

DEALERS WILL INSPECT THE POWER STEERING LOW-PRESSURE LINE TO ENSURE THAT IT IS SEATED PROPERLY AT THE RACK AND PINION STEERING GEAR. OWNER NOTIFICATION BEGAN NOVEMBER 10, 2003. OWNERS SHOULD CONTACT FORD AT 1-800-392-3673.

On certain vehicles originally sold or currently registered in areas of heavy road salt usage during winter months (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador), corrosion can occur at the latch for the forward portion of the third row seat. Continued corrosion in this area may result in the inability to fully latch the forward portion of the seat into its seating position, which could increase the risk of injury in a crash. Note: Seat belt anchorages and permanent seat anchorages, which are at the rear of the seat, are unaffected. Correction: Dealers will install new third row seat latch striker mounting brackets which relocate the seat latch strikers from the potentially corroded area. In addition, dealers will install overlay panels on the exterior of the wheel wells to prevent entry of water and corrosive elements.

On certain vehicles, the torque converter could fail. This would result in a loss of vehicle propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the torque converter assembly.

Certain Ford Freestar vehicles modified for wheelchair accessibility by Liberty Motor Company Inc. do not comply with the requirements of CMVSS 210. The second row bench seat only has one set of lower universal anchors (UAS) instead of the required two sets. Also, certain vehicles do not have tether anchor brackets for the bench's two outboard seating positions. This non-compliance would prevent proper installation of a child seat to an outboard seating position. Correction: Owners should contact Liberty Motor Company and then bring their vehicles to a trusted service shop or Ford dealership to have two tether anchors and two UAS brackets installed.

On certain vehicles, the front wheel hub assemblies were not heat treated correctly. This condition may lead to the development of small cracks in the hub. If the cracks were to progress, this could eventually result in wheel separation. Wheel separation may lead to loss of vehicle control, and potentially result in a vehicle crash. Correction: Dealers will replace the front wheel hub and rotor assemblies.

Certain vehicles do not comply with the requirements of CMVSS 120. The Standard specifies that for vehicles other than passenger cars, the label information shall display after each GAWR, the size designation and, if applicable, the type designation of rims. This information was inadvertently omitted from the compliance label affixed to the affected vehicles. Correction: Since this does not pose any safety risk, no corrective action is required.

On certain vehicles, the low-pressure power steering return line connection may not have been fully seated at the steering gear during vehicle assembly. If the return line is not fully seated, a power steering fluid leak may occur. A power steering fluid leak may create the potential for power steering fluid to come in contact with the exhaust system, which could result in smoke or fire. Correction: Dealer will inspect the power steering return line connection.